PE100 pipe can be supplied in coils up to DN180. For all diameters that are too large to be supplied in coils the pipe will be supplied to site in straight lengths. These will be butt fusion welded...
The four ISO systems Standards, ISO 11296-11299 cover plastic pipes in renovation of gravity sewerage, pressure sewerage, water and gas supply respectively. Each requires that an installation manual...
Close-fit Lining Methods Whilst restoring the internal diameter is not critical for slip lining, it is critical if a close fit or tight fit technique is to be used. The host pipe must be thoroughly...
Trenchless installation and rehabilitation techniques that use standard PE100 or PE100-RC pipes also use standard end fittings to connect to other pipe materials. These may be fused or mechanical...
On completion of the trenchless installation or rehabilitation works using PE100 or PE100-RC the works must be inspected and tested. This inspection and testing follows the normal procedures of the...
Apart from slip lining, the three techniques for rehabilitating large diameter mains with PE100 or PE100-RC liner pipe are die drawing, rolldown, and folding, and in these three cases the liner pipe...
For all trenchless methods, both new installation and rehabilitation, it is necessary to excavate at each end of the works to reach the working depth for installation or the host pipe for...
Any rehabilitation or replacement works on pressure mains require the sections of main being rehabilitated or replaced to be isolated from the system. Procedures for isolation when using any of the...
Members of the Association
Top articles
PE100+ position letter on ANPT
(SCG) resistance on pipes for pressure applications since many years. With the introduction of PE 100-RC materials in EN 1555, EN 12201 and ISO...
PE 100-RC+ Quality Materials List
PE 100-RC+ materials have become an essential and well established sub-family of PE 100 compounds. They have a higher stress crack resistance and...
PE 100+ association leads permeation tests for H2 ready certification
A number of gas utilities and grid owners have approached the PE 100+ association regarding the suitability of PE 100 pipe systems for the...
Why choose PE compounds for pressure pipe ?
Simplicity or consistency There are two approaches to PE100 pipe manufacture: Fully compounded. The polymer producer manufactures and supplies to...
PE100+ Quality Materials List
PE100+ Quality Materials List is valid until December 2024. It is available online and a PDF version can be downloaded at the bottom of this page.
Testing methods
Creep rupture strength - Internal pressure test Constant internal pressure at constant temperature The internal pressure test is standardised in ISO...
Pipe Reaming
PIPE REAMING - TECHNIQUE Pipe reaming , also known as pipe eating , is a trenchless pipe replacement technique that removes the host pipe while at...
Pipe Bursting and Splitting
PIPE BURSTING / SPLITTING - TECHNIQUE Pipe bursting and pipe splitting are trenchless methods used to replace existing pipelines with PE100 or...
What range of pipe dimensions is available?
PE100 can be manufactured in a wide range of polyethylene pipe diameters from 16mm to 2000mm. Even larger diameters are possible with the...