Our site uses cookies necessary for its proper functioning. To improve your experience, other cookies may be used: you can choose to disable them. This can be changed at any time via the Cookies link at the bottom of the page.


Design and Manufacture OF GRP Liners and Their Installation

 

Materials and their Characteristics

Plastic Pipes Conference Association # 1982 York

Cooper

Deterioration of the sewers in our cities has produced an urgent requirement for a technically satisfactory cost-effective means of renovating or upgrading existing underground services. One of the most successful methods available is the insertion of a preformed liner into the pipeline with the annular gap being filled with a suitable material. GRP liners with their combined properties of light weight and high strength with good flow properties and corrosion resistance are eminently suitable for this purpose. Details are given of manufacture and installation and design methods are discussed.

Please note that the whole article content is available on PPCA website only :

Related papers

1970 Southampton : Cold Water Plumbing Services in Plastics Piping

Author(s) : Cooper

The use of plastics piping for the conveyance of cold water goes bsck uell over 30 years, when polythene tube was first used for the purpose in experimental installations. It was not until 135.3, however, that a Brltish Staridarcl was published foe Po!ythene Pipe for Cold Water Services - in those days there was, of...

Members of the Association

BOREALISBOROUGEFormosa Plastics CorporationHanwha TotalEnergiesINEOS O&PIRPCKorea Petrochemical IND. Co., LTD (KPIC)LyondellBasellORLEN UnipetrolPetroChina Dushanzi Petrochemical CompanyPRIME POLYMERSABICSCG Chemicals & Thai PolyethyleneSinopecTASNEE